Your Local Electrician in Pine, Colorado
Pine and Pine Junction sit ten minutes up US-285 from our shop in Bailey. Tri Peaks Electric has wired detached garages, barns, well pumps, and generator hookups on Pine acreage since 2006 — no travel fees, no subcontractors.
Does Tri Peaks Electric Serve Pine, CO?
Yes. Tri Peaks Electric Service is a licensed, insured electrical contractor serving Pine and Pine Junction, CO from our home base in Bailey, less than ten miles down US-285. There is no travel fee for Pine, and owner David Martinez is the lead electrician on every job.
Pine properties tend to be larger than the rest of the corridor — acreage lots, detached shops, barns, and long driveways. That means long underground conduit runs, subpanels in outbuildings, well pumps, and backup power for outages that can last days. That's the work we do most in Pine.
Built for Pine's Acreage Properties
Most Pine calls start with an outbuilding. A detached garage, a workshop, a barn, or a guest cabin needs real power — not an extension cord across the yard. We trench and run underground feeders, install a subpanel in the structure, and pull the Jefferson County permit so the work passes inspection and resale.
The second most common call is backup power. Pine and Pine Junction lose power in wind and snow events more often than the metro area, and when the power goes, so does the well pump. A 30A or 50A generator inlet with a transfer switch keeps water, heat, and refrigeration running from a portable generator.
David Martinez handles every Pine job personally — you talk to the electrician doing the work, from the estimate to the final inspection.
Outbuilding & Shop Subpanels
Underground feeders and subpanels for detached garages, barns, and workshops on Pine acreage.
Generator Inlets & Transfer Switches
30A and 50A inlets so a portable generator can run the well pump, furnace, and fridge.
Panel Upgrades
200A service upgrades for Pine homes adding EV chargers, hot tubs, or a second structure.
Well Pump & Electrical Repairs
Troubleshooting for well pump circuits, tripping breakers, and dead outlets.
What's Different About Electrical Work in Pine
Long runs, real voltage drop
A 200-foot run to a shop needs larger wire than the same circuit inside a house. We size feeders for the distance so tools and chargers get full voltage at the far end.
Rocky trenching
Pine's granite and decomposed-granite soil makes trenching slow. We plan conduit routes with that in mind and coordinate trenching so you're not paying for two crews to dig twice.
Well pumps are life support
When power drops, water stops. We wire generator inlets so the well pump circuit is on the transfer switch, not left behind on the main panel.
Jefferson County permits
Pine falls under Jefferson County building. We pull the electrical permit, schedule the inspection, and close it out on every subpanel, generator, and service job.
Why Pine Homeowners Choose Tri Peaks
Every Electrical Service We Offer in Pine, CO
We work throughout Pine Junction, Pine Grove, Elk Creek Highlands, and the acreage along Highway 126.
Pine properties are bigger, farther apart, and more likely to have a shop, barn, or guest cabin than anywhere else on the corridor. That means long feeders, subpanels, and backup power. Here is everything we handle in Pine.
Electrical service calls and troubleshooting
Tripping breakers, dead outlets, flickering lights, and anything that smells hot. We diagnose with a meter and fix it the same day in most Pine homes.
Panel upgrades and service upgrades
100A-to-200A upgrades and Federal Pacific, Zinsco, and fuse-box replacements, permitted through Jefferson County and inspected.
Sub panels for garages, shops, and ADUs
Underground or overhead feeders to a detached structure, with a properly grounded subpanel sized for what you actually run out there.
Hot tub and spa circuits
A Pine hot tub often sits a long way from the main panel. We run the 50A circuit underground in conduit, size the wire for the distance, and put the GFCI disconnect within sight of the tub.
EV charger circuits
Dedicated 50A/240V circuits and Level 2 chargers for any EV brand, with a load calculation first so the panel can handle it.
Generator inlets and standby generators
30A and 50A inlets with transfer switches for portable units, or a full standby system sized for Pine's outages.
Lighting fixtures, recessed cans, and outdoor lighting
Kitchen and under-cabinet lighting, recessed cans in vaulted ceilings, security and landscape lighting rated for mountain weather.
Well pump wiring and controls
Nearly every Pine home is on a well. When the power goes, water goes with it, so we wire the well pump onto the generator transfer switch and troubleshoot pump controls and pressure switches year-round.
Ceiling fans, switches, outlets, and GFCI
Fan installs on vaulted ceilings, dimmer and switch replacement, GFCI and AFCI protection, and fixing ungrounded two-prong outlets.
Home electrical safety inspections
A written report on your panel, wiring, grounding, and outdoor circuits before you buy, sell, insure, or add load to a Pine home.
More for Pine Homeowners
Pine sits between Bailey and Conifer. Here's the related work we do up and down this stretch of US-285.
- Generator Installation →Standby generators, transfer switches, and 30A/50A inlets for mountain outages.
- Remodels & Additions →Kitchens, ADUs, garages, and additions wired from rough-in to final inspection.
- Electrician in Conifer, CO →Panel replacements and aluminum wiring remediation for 1970s–80s Conifer homes.
- All Service Areas →Bailey, Pine, Conifer, Evergreen, Indian Hills, Morrison, Fairplay, and West Metro Denver.
- Meet David Martinez →Licensed master electrician, 20 years in the field, lead on every job since 2006.
- See Our Work →Real photos from panel, EV charger, generator, and lighting jobs on the 285 Corridor.
Pine Electrician Questions
Ready to Get Started?
Call or book online today. We serve Bailey, Conifer, Evergreen, and the entire 285 Corridor. Fast response — licensed & insured.